Multitech MT5634MU User Manual page 40

MultiMobile USB User Guide
Command: \Q n Flow Control Selection
n = 0, 1, or 3
Values:
Default: 3
Disable flow control (same as &K0 ).
Description: \Q0
XON/XOFF software flow control (same as &K4 ).
\Q1
\Q2 CTS-only flow control. Not supported.
\Q3 RTS/CTS hardware flow control (same as &K3 ).
Command: \T n Inactivity Timer
Values: n = 0, 1–255
Default: 0
Description: \Tn Sets the time (in minutes) after the last character is sent or received that the modem waits be-
fore disconnecting. A value of zero disables the timer. Applies only in buffer mode.
Note: You can also set the inactivity timer by changing the value of S30 .
Command: \V n Protocol Result Code
n = 0, 1, or 2
Values:
Default: 1
Description: \V0 Disable the appending of the protocol result code to the DCE speed.
\V1 Enable the appending of the protocol result code to the DCE speed.
\V2 Same as \V1 .
Command: \X n XON/XOFF Pass-Through
Values: n = 0 or 1
Defaults: 0
Description: \X0 Modem responds to and discards XON/XOFF characters.
\X1 Modem responds to and passes XON/XOFF characters.
Command: -C n
Data Calling Tone
Values: n = 0 or 1
Defaults: 0
Description: -C0 Disable V.25 data calling tone to deny remote data/fax/voice discrimination.
-C1 Enable V.25 data calling tone to allow remote data/fax/voice discrimination.
Command: %A Adaptive Answer Result Code Enable
Values: n = 0 or 1
Defaults: 0
The %A command controls whether the DATA and FAX result codes will be sent by the modem.
Description:
The modem must be in fax mode for this command to work. Also, the modem must be set to
+FAA=1 which enables the modem to distinguish between a fax and a data call. When these
commands are enabled, the modem sends DATA to the computer when it detects data tones
and FAX when it detects fax tones. These strings are used by some servers to select the appro-
priate communication program.
%A0 Disables adaptive answer result codes.
%A1 Enables adaptive answer result codes.
Command: %B View Numbers in Blacklist
Values: n/a
Description: If blacklisting is in effect, AT%B displays the numbers for which the last call attempted in the
previous two hours failed. In countries that do not require blacklisting, the ERROR result code
appears.
40