Set Supervisor / User Password; Save & Exit Setup - Multitech IAC-F696 User Manual

Set Supervisor / User Password

The SUPERVISOR/USER PASSWORD utility sets the password. The SBC is shipped with the password
disabled. If you want to change the password, you must first enter the current password, then at the
prompt -- enter your new password. The password is case sensitive, and can be up to 8 alphanumeric
characters. Press <Enter> after you have finished typing in the password. At the next prompt, confirm the
new password by re-typing it and pressing <Enter> again. When you are done, the screen automatically
reverts to the main screen. Remember that when you use this feature, the Security Option line in BIOS
FEATURES SETUP will determine when entering the password will be required.
Phoenix - Award BIOS CMOS Setup Utility
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management
PnP / PCI Configuration
ESC : Quit
F10 : Save & Exit Setup
Change/Set/Disable Password
To disable the password, press the <Enter> key instead of entering a new password when the Enter
Password in the dialog box appears. A message will appear confirming that the password is disabled.
If you have set both supervisor and user password, only the supervisor password allows you to enter the
BIOS SETUP PROGRAM.
Note: If you forget your password, the only way to solve this problem is to discharge the CMOS
memory.
Save & Exit Setup
Select this option and press the <Enter> key to save the new setting information in the CMOS memory
and continue with the booting process.
Phoenix - Award BIOS CMOS Setup Utility
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management
PnP / PCI Configuration
ESC : Quit
F10 : Save & Exit Setup
Save Data to CMOS
Multi-Tech Systems, Inc. Single Board Computer IAC-F696 User's Guide (S000349A)
PC Health Status
Load Optimized Defaults
Set Supervisor Password
Set User Password
Enter Password:
: Select Item
PC Health Status
Load Optimized Defaults
Set Supervisor Password
Set User Password
SAVE to CMOS and EXIT (Y/N)? Y
: Select Item
Setup
Saving
Setup
Saving
Chapter 3- BIOS Setup
40