Pnp/Pci Configuration; Pnp/Pci Configuration Setup Screen - Multitech IAC-F696 User Manual

PnP/PCI Configuration

Both the ISA and PCI buses on the CPU card use system IRQs & DMAs. You must set up the IRQ and
DMA assignments correctly through the PnP/PCI Configuration Setup utility; otherwise the motherboard
will not work properly.

PnP/PCI Configuration Setup Screen

Phoenix - Award BIOS CMOS Setup Utility
PnP/PCI Configurations
PNP OS Installed
Reset Configuration Data
Resources Controlled By
IRQ Resources
DMA Resources
PCI/VGA Palette Snoop
Assign IRQ For VGA
Assign IRQ For USB
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
Move Enter: Select
F5: Previous Values
The following explains the options for each of the features as listed in the above menu:
PNP OS Installed: When set to Yes, BIOS will only initialize the PnP cards used for booting (VGA, IDE,
SCSI). The rest of the cards will be initialized by the PnP operating system like Windows® 95 or 98.
When set to No, BIOS will initialize all the PnP cards. So, for non-PnP operating system (DOS,
Netware®), this option must set to Yes.
Reset Configuration Data: Normally, you leave this field Disabled, Select Enabled to reset Extended
System Configuration Data (ESCD) when you exit Setup if you have installed a new add-on and the
system reconfiguration has caused such a serious conflict that the operating system cannot boot.
The settings are: Enabled and Disabled.
Resource Controlled By: The Award Plug and Play BIOS has the capacity to automatically configure all
of the boot and Plug and Play compatible devices. However, this capability means absolutely nothing
unless you are using a Plug and Play operating system such as Windows98. If you set this field to
Manual choose specific resources by going into each of the sub menu that follows this field (a sub menu
is proceeded by a ). The settings are Auto (ESCD), Manual.
Multi-Tech Systems, Inc. Single Board Computer IAC-F696 User's Guide (S000349A)
[No]
[Disabled]
[Manual]
[Press Enter]
[Press Enter]
[Disabled]
[Enabled]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
+/-/PU/PD: Value
F6: Fail-safe Defaults F7: Optimized Defaults
Item Help
Menu Level
Select Yes if you
are using a Plug
and Play capable
operating system.
Select No if you
need the BIOS to
configure non-boot
devices.
F10: Save Esc: Exit
Chapter 3- BIOS Setup
F1: General Help
37