Multitech CommPlete 4000 Quick Start Manual page 13

A12. In the Primary Name Server field and the Secondary Name Server fields,
type
unless you have made other arrangements.
A13. In the IP Frame Type field, select TYPE_II (the default value).
A14. If you set the Remote Client IP Address field to the value Configure Per Port,
follow these steps when this present Quick Configuration procedure is done:
i.
ii.
iii.
iv.
These steps correct the initial subnet error the next time the server loads.
If you set the Remote Client IP Address to any of these values (Use DHCP, or Use
Address Pool, Use Radius), go to step A15. If you selected Use Address Pool,
you must configure the address pool. See the RAS Express User Guide.
A15. When the above steps are complete, press Esc and save the changes to disk. You will be
asked to re-boot the server.
A16. Type Y and press Enter. The connection closes while the RAS Express server re-boots. A
new menu appears after the CommPlete 4000 has re-booted.
A17. To complete the configuration of the RASExpress server, select Configuration of
server from the main menu. For detailed information about the menu options, see Chapter 3
of the RAS Express manual.
CommPlete 4000 Communications Server Quick Start Guide
000.000.000.000
From the terminal main menu, select Configuration of server
Select Communication Setup.
Select ISI Setup.
Delete all ISI cards before saving and rebooting the server.
Getting Started with RASExpress
13