FCS-3
Fig. 1:
Cicuit Diagram
Checking the package contents
Check the contents of the package for completeness after unpacking:
§
one module,
§
additional components: one resistor 10 kΩ, one diode 1N4148, one
transistor BC 327, one reed-contact,
§
one manual.
Required tools and materials
Make sure you have the following tools and materials ready for use:
§
an electronic soldering iron (max. 30 Watt) with a fine tip,
§
a soldering iron stand,
§
a tip-cleaning sponge and a heat-resistant mat,
§
a small side cutter and wire stripper,
§
a pair of tweezers,
§
tin solder (0,5 mm. diameter),
§
enamelled copper wire or thin connecting wire,
§
LEDs for the lights,
§
if necessary: series resistors for the front lights.
English
Seite 25