Table of Contents
Advertisement
FCS-3
English
In order to check which one of the two connecting points of side B you
have to connect to the module, connect temporarily the minus pole of the
motor to the minus pole of the accumulator battery and the plus pole of
the motor to one of the two connecting points at side B of the reed
contact. If the motor does not run with this connection, you have to
connect this connecting point to the connecting point X8 and the
enclosed resistor R10. If the motor runs with this connection, you have
to connect the other connecting point to the connecting point X8 and
the enclosed resistor R10. Finally disconnect the temporary connections
of the motor. Connect the second side of the resistor R10 to the
connecting point X3.
Connection of the additional reed contact
The additional reed contact has to be mounted as far as possible in front
of the vehicle. Connect the enclosed reed contact to the connecting points
X3 and X9.
!
Caution:
Reed contacts are sensitive to stress. Therfore be careful when bending
the legs in oder not to destroy the glass bulb.
Connection of the motor
Connect the enclosed diode 1N4148 to the connections of the motor.
Observe the polarity of the diode. Then connect the minus pole of the
motor to the connecting point X1. Next connect the collector (C) of the
enclosed transistor BC 327 to the plus pole of the motor, the basis (B)
to the connecting point X4 and the emitter (E) to the resistor R7. If
there is no resistor R7, connect the emitter directly to the plus pole of
the accumulator battery.
Connection of the LEDs for the flash lights
The two LEDs for the flash lights on the left or the right have to be
connected in series, i.e. the anode (+) of the one LED has to be connected
to the cathode (-) of the other LED. Next connect the disconnected anode
with connecting point X5 (flash lights on the right) or X7 (flash lights on the
left) and the disconnected cathode with connecting point X3.
Seite 29
Advertisement
Table of Contents
