Advertisement
d. Attach the Camera Body to the Base Plate. Screw back the Fix Screw.
3. Connect the Power Cable to a 12VDCpower source. Connect the Video
Output Cable to a monitor or DVR.
4. You can use the Joystick on the cable to configure camera OSD settings or
switch to different video formats. Remove the Protection Cap from the
Joystick before using it.
5. You can optionally adjust the camera angles. To do so, unscrew the 4 cover
screws using the supplied L-Type Wrench and then remove the cover. Adjust
the camera angles (Tilt: 90°, Pan: 180°, Rotate: 90°). After adjusting camera
angles, screw back the camera cover.
Switching Video Format:
Push the joystick up for 5 sec. to switch to
resolution1080p/720p.
Push the joystick right for 5 sec. to switch to AHD.
Push the joystick down for 5 sec. to switch to
NTSC/PAL.
Push the joystick left for 5 sec. to switch to CVBS.
Push the joystick center to enter main menu.
Configuring OSD Settings:
Push the Joystick up / down to select among
menu items.
Push the Joystick left / right to adjust the level of
the selected item.
Press the Joystick to enter the sub-menu or exit
the OSD Setup Menu.
4
Advertisement
