How To Turn The Power On/Off - Furuno FE-800 Operator's Manual

1.2

How to Turn the Power On/Off

Note 1: Make sure the unit is connected correctly to each transceiver.
Note 2: After turning the unit off, wait at least 5 seconds before you turn the power on again.
Press the button to turn the unit on. With the power on, press the
unit off.
On startup, the unit displays a splash screen for approximately ten seconds, then begins a
self-test. The self-test checks the logic circuits, battery status and displays the program version
currently in use.
After the self-test completes, the mode used before the FE-800 was turned off is activated. You
can now change modes freely (See section 1.4.)
Note: If any errors occur during the self-test process, the self-test stops the startup procedure.
Contact your local Furuno dealer for service.
Splash screen
Unit Name : FE-8010
Serial No : XXXXXX
Program No : 1251002-01.xx
ROM
: OK
RAM
: OK
Unit Name : FE-8020
Serial No : XXXXXX
Program No
: 1251003-01.xx
ROM
: OK
RAM
: OK
Unit Name : FE-8020
Serial No : XXXXXX
Program No
: 1251003-01.xx
ROM
: OK
RAM
: OK
Press any Key to continue.
Self-test results
Display unit's self-test
results
Transceiver test results.
NOTE: Only connected
transceivers are tested.
Transceiver test results
appear after approximately
ten seconds.
2
1. OPERATION
button again to turn the