Using The Diagnostic Self-Test - IBM WebSphere DataPower 7198 Installation And User Manual

v [success] Reuwinterface expected - 4 interfaces found
v [success] MAC address of interface 'eth10' is 00:11:25:27:bf:e7
v [success] Statistics for interface 'eth10' show no errors
v [success] 6 fans expected - 6 fans found
v [success] fan 1 operating within expected range
v [success] Status of the crypto 'standard' is fully operational
Samples of warning statements are as follows:
v [warning] Backtrace file exists.
v [warning] Physical link on interface 'eth10' is down.
v [warning] eth10 has invalid MAC (ff:ff:ff:ff:ff)
Samples of failure statements are as follows:
v [failure] Expected number of interfaces: 4 - Found: 1
v [failure] fan 2 operating outside expected range (rpm too low)
v [failure] Status of crypto 'not detected' is unknown.
The output of the test hardware command is part of any generated error report.

Using the diagnostic self-test

The Type 7198 and 7199 appliance provides a boot-time diagnostic self-test to help
you test hardware components.
Note: Only use the diagnostic self-test when directed by IBM Support to help
To initialize the diagnostic self-test:
1. Connect the serial cable.
2. If the appliance is not turned on, press the power button to turn on the
3. When you see DPOS boot - press <ESC> within 7 seconds for boot options,
4. At the DPOS prompt, enter diagnostics to start the appliance and display the
34
Installation and User's Guide
confirm a potential hardware problem with the appliance.
appliance. The green power LED will illuminate. You should hear the fans start
up.
press ESC with seven seconds. You should see the DPOS prompt followed by the
boot options menu.
DPOS boot - press <ESC> within 7 seconds for boot options.. <ESC>
DPOS> ?
Available DataPower boot options:
Boot Option Description
------------ ------------------------------------------
system Normal System Startup
diagnostics Run Standalone Hardware Diagnostics
DPOS>
diagnostics main menu.