Initial Start-Up; Checking The Battery Charge Level; Inserting/Removing The Device's Battery Pack; Selecting A Tool - Parkside PBHA 12 A1 Translation Of The Original Instructions

Initial start-up

Place the rotational direction switch
into the central position before car-
rying out any work with the electri-
cal tool (e.g. maintenance, change
of tool etc.), as well as during
transportation and storage. There is
a risk of injury if the on-off switch is
accidentally activated.
Checking the battery charge
level
The battery's (
9) charge level is indi-
cated by the charge state indicator (
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (
red-yellow-green => Battery fully charged
red and yellow => Battery half charged
red
=> Battery needs
Inserting/removing the device's
battery pack
Inserting the battery pack:
• Push the rotational direction switch
( 7) into the central position (lo-
cked). Allow the battery pack (
latch into the handgrip.
Removing the battery pack:
• Press the button (
remove the battery pack (

Selecting a tool

An SDS Plus attachment tool is required for
impact drilling.
8).
to be charged
9) to
10) to unlock and
9).
Use the keyless chuck with SDS Plus adap-
ter for drilling without impact into wood,
metal, ceramic and plastic.
You can insert cylindrical drill bits with a
diameter of 0.8 - 10 mm into this chuck, or
an attachment tool with a hexagonal shaft.
For screwing, use the screw bits that are
inserted via the keyless chuck with SDS
Plus adapter.
The "impact drilling" operating
mode may only be used if the key-
less chuck is not attached!

Changing the tool

6).
The tool holder with SDS Plus adapter
allows you to change the attachment tool
easily and conveniently without use of ad-
ditional tools.
The attachment tool is freely movable for
technical reasons. This causes a concen-
tricity deviation during idling but this has
no effect on the accuracy of the bore hole
since the drill centres itself automatically
while drilling.
The device is capable of using various drill
bit types featuring a hexagonal or cylind-
rical shaft thanks to the keyless chuck with
SDS Plus adapter.
The dust protection cap (2) largely prevents
the ingress of drilling dust into the tool
holder during operation. Ensure the dust
protection cap (2) is not damaged when
inserting tools.
If damaged, the dust protection cap
must be replaced immediately. It is re-
commended for this to be performed
by customer service.
GB CY
11