11. Removal Procedure
11.1 Removal Procedure of Indoor Unit
Step
the groove on the front panel.
respectively.
2. Remove horizontal louver
Push out the axile bush on horizontal
louver. Bend the horizontal louver with
hand and then separate the horizontal
louver from the crankshaft of step motor
to remove it.
3. Remove panel and display
a
Separate the panel rotation shaft from
removes the front panel.
Screw off the 2 screws that are locking
b
the display board.
44
Caution: discharge the refrigerant
completely before removal.
Procedure
Front panel
Horizontal louver
Front panel
Panel rotation
Groove
Groove
Location of step motor
Axile bush
Panel
Display
Installation and Maintenance
Service Manual
Front
case
Screws