Removal Procedure; Removal Procedure Of Indoor Unit - Lennox LI009HI-160T432 Service Manual

Service Manual

11. Removal Procedure

11.1 Removal Procedure of Indoor Unit

LI009HI-160T432 LI012HI-160T432
Step
1. Remove filter assembly
Open the front panel. Push the left filter
and right filter until they are separate from
the groove on the front panel.
Remove the left filter and right filter
respectively.
2. Remove horizontal louver
Push out the axile bush on horizontal
louver. Bend the horizontal louver with
hand and then separate the horizontal
louver from the crankshaft of step motor
to remove it.
3. Remove panel
a
Screw off the 2 screws that are locking
the display board.
b Separate the panel rotation shaft from
the groove fixing the front panel and then
removes the front panel.
Installation and Maintenance
Caution: discharge the refrigerant
completely before removal.
Procedure
Front panel
Left filter
Horizontal louver
Front panel
Panel rotation
Groove
Right filter
Groove
Location of step motor
Axile bush
Panel
Display
Screws
Front
case
71