Recycling The Pcba - Cisco UCS 6500 Series Installation Manual

Fabric interconnecthardware

Hide thumbs Also See for UCS 6500 Series:

Table of Contents

Replacing Components

Step 2

Test the installation by trying to pull the power supply out of the slot without using the release latch.

If the power supply does not move out of place, it is secured in the slot. If the power supply moves, carefully

press it all the way into the slot until it clicks in place.

Step 3

Attach the power cable to the electrical outlet on the front of the power supply (3).

Step 4

Make sure that the other end of the power cable is attached to the appropriate power source for the power

supply.

Note

Step 5

Verify that the power supply is operational by making sure that the power supply OK LED is green and the

FAIL LED is dark.

Recycling the PCBA

The PCBA is secured to the fabric interconnect's sheet metal through the following:

• 32 M3 screws.

• Two M5 hex nuts.

You must disconnect the PCBA from the sheet metal before recycling the PCBA.

Depending on the outlet receptacle on your power distribution unit, you might need the optional

jumper cable to connect the fabric interconnect to your outlet receptacle.

Cisco UCS 6500 Series Fabric Interconnect Hardware Installation Guide

Recycling the PCBA

Table of Contents