Table of Contents
Advertisement
Installing the Fabric Interconnect Using the UCS-ACC-6536 Kit
c) Repeat Step 3 to attach the other slider rail to the other side of the rack.
To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or
carefully count the screw holes in the vertical mounting rails.
Step 4
Insert the fabric interconnect into the rack and attach it as follows:
a) Holding the fabric interconnect with both hands, position the two rear rack-mount brackets on the fabric
interconnect between the rack or cabinet posts that do not have slider rails attached to them (see the
following figure).
b) Align the two rear rack-mount guides on either side of the fabric interconnect with the slider rails installed
in the rack. Slide the rack-mount guides onto the slider rails, and then gently slide the fabric interconnect
all the way into the rack until the front rack-mount brackets come in contact with two rack or cabinet
posts.
Cisco UCS 6500 Series Fabric Interconnect Hardware Installation Guide
22
Installing the Fabric Interconnect
Advertisement
Table of Contents
