Mitsubishi Electric WD-60737 Owner's Manual page 56

56
6. NetCommand Control of an A/V Receiver (837 Series)
Setting Up A/V Receiver Control, continued
4.
If using an optional audio cable between the TV and
A/V receiver, connect it.
5.
Connect the IR emitter cable to the TV and position
the IR emitter where it can send signals to the A/V
receiver. See "IR Emitter Placement," page 46.
Setup to Control Automatic Audio
and Video Switching via HDMI
When this setup is complete, the "learned" A/V receiver
input will appear in the TV's Activity menu as a select-
able input.
1.
Power on the A/V receiver.
2.
TV's remote control to TV mode using the
Set the
side button.
3.
Power on the TV.
4.
When the New Device Found screen displays,
select device name AVR if it is not recognized auto-
matically.
5.
Inputs > AVR menu or, from
Navigate to the
within the New Device Found screen, highlight
NetCommand and press ENTER.
To set up A/V switching over HDMI, choose your
devices from a list. Unlike the device list described for
Case 2, this is a generic list containing more than just
the devices detected in your setup.
6.
Inputs > AVR menu, press
In the
the name of the A/V receiver input to control. In
this example, it is the DVD input.
7.
Press ENTER on the TV's remote control.
8.
DVD is flashing, press and hold the
While the text
DVD INPUT key on the A/V receiver's remote control.
9.
When a check appears next to
DVD INPUT key.
• If the text stops flashing before the check mark
appears, repeat this step.
• To erase the IR code just "learned," press
CANCEL while the name is highlighted.
10.
If there are no more devices to set up, highlight
EXIT and press ENTER or continue to set up addi-
tional A/V receiver audio/video sources.
to highlight
DVD, release the
NetCommand Control of a Device Con-
nected to an HDMI A/V Receiver
Use this setup to have NetCommand control a device
sending audio and video through the A/V receiver to the
TV via HDMI.
You must have already completed the procedure under
"Setup to Control Automatic Audio and Video Switching
via HDMI" on this page. That procedure placed an icon
in the Activity menu for the device (input) connected to
the A/V receiver.
Any Connection
Type
Source
Device
1.
Set up NetCommand control of A/V receiver audio/
video switching via HDMI as described on this
page.
2.
BACK to close any open menus and return to
Press
normal TV viewing.
3.
Press ACTIVITY.
4.
Highlight the icon for the A/V receiver input you
wish to control.
5.
ENTER to switch the TV to the A/V receiver
Press
and the A/V receiver to the input.
6.
Open the Inputs > Learn menu.
7.
Perform NetCommand "learning" for the con-
nected )device by following the steps in "Initial
NetCommand Setup," page 47.
HDMI
Cable
A/V
TV
Receiver