Setting Up A/V Receiver Control; Power And Volume - Mitsubishi Electric WD-60737 Owner's Manual

52
6. NetCommand Control of an A/V Receiver (837 Series)

Setting Up A/V Receiver Control

Power and Volume

Perform this setup to control the A/V receiver power
and volume with the TV's remote control.
To perform this setup you need:
• The remote controls for both the TV and the
A/V receiver.
• An IR emitter cable available from Mitsubishi.
Before You Begin
1.
Connect your A/V receiver to the TV and any addi-
tional devices. See "Setting Up TV Inputs," page 10
and "TV Connections," page 14.
2.
Connect the IR emitter cable to the TV and position
the IR emitter where it can send signals to the A/V
receiver. See "IR Emitter Placement," page 46.
3.
Set the TV's remote control to TV mode using the
side button.
Setup to Control A/V Receiver Power and Volume
1.
Inputs > AVR screen in one of two ways:
Open the
• If using the New Device Found screen for the
A/V receiver, highlight NetCommand and press
ENTER to open the AVR screen.
• If performing NetCommand setup at any time
after Auto Sensing:
Press MENU, highlight Inputs, and highlight AVR
to open the AVR menu.
2.
The first function highlighted in the
always Power. Aim the TV's remote control at the
TV and press ENTER to begin learning for Power.
IMPORTANT
To hear audio sent from the TV to the A/V receiver,
you must have:
Physically connected the TV to the A/V receiver
•
via the analog or digital audio output.
• Assigned, if needed, the name AVR if using an
HDMI A/V receiver.
• " Learned" the IR codes for the A/V receiver
inputs.
Assigned the TV's audio output to the correct
•
input in the NetCommand Inputs > AVR menu.
• Selected the A/V receiver as the audio source.
Press MORE then 9 (AUDIO), then
the Speakers option, then
Receiver.
AVR screen is
to show
to select the A/V
Inputs > AVR screen. Perform
NetCommand IR "learning" for A/V
receiver power and volume keys.
3.
When the Power text starts flashing, aim the A/V
receiver's remote control at the TV and hold the
POWER or POWER ON key until a check mark appears
next to Power.
• If the text stops flashing before the check mark
appears, repeat this step.
• To remove the key from NetCommand control,
press the CANCEL key while the key name is
highlighted.
4.
Press the key on the TV's remote control to highlight
other keys in the list. Repeat steps 2 and 3 for each addi-
tional function you wish to control through NetCommand.
5.
If the A/V receiver has a separate
on the TV's remote to highlight Power Off.
press
Repeat steps 2 and 3 to "learn" the POWER OFF key.
If the device has no POWER OFF key, skip this step.
6.
When finished "learning" the power and volume
keys, either
• To watch TV, press
• To continue with NetCommand setup to control
switching of A/V receiver inputs, highlight
NEXT and press ENTER.
POWER OFF key,
BACK .