Advertisement
7
9588
3x16mm SS
9588
3x16mm SS
Remove the chassis brace (T-Bar) from the chassis by removing the
3x16mm shoulder screws (2) and lifting up on the bar as shown.
9 A
10
9588
3x16mm SS
9588
3x16mm SS
11
Use an included zip tie to secure the wiring from
the breakaway cable adapter to the zip tie mount
on the adapter.
9523
Chassis Brace
(T-Bar)
Connector not fully seated
9693
Breakaway
Cable
Adapter
9523
Chassis Brace
(T-Bar)
8
Remove the 3x25mm
button-head screws (2)
from the electronic speed
control (ESC) to remove
the cooling fan cover.
Remove the accessory
port cover (discard or
save for future use).
Feed the connector from the breakaway
cable adapter through the accessory
port opening on the ESC cooling fan
cover (9A). Plug the connector into
the accessory port on the ESC; note
orientation of the connector.
Reinstall the cooling fan cover on the ESC
using the 3x25mm button-head screws.
Be careful not to pinch the ESC wires
during reinstallation (9B).
Install the breakaway cable adapter onto the T-Bar and slide it near the
Traxxas logo; then, reinstall the T-Bar on the chassis using the removed
screws. Note: The location of the breakaway cable adapter on the
T-Bar can be adjusted as you plug the adapter into the accessory port
on the ESC.
CAUTION: RISK OF DAMAGE TO
ELECTRONICS!
electronic speed control (ESC) and/or the high-voltage power
amplifier, ensure the battery is disconnected before plugging the
amplifier into the ESC.
Plug the cable from the high-voltage power amplifier on the body into
the breakaway cable adapter on the chassis brace (T-Bar). Refer to the
Body Wiring and Chassis Wiring Diagrams on the following page.
3x25mm BCS
Accessory Port
Cover
9 B
3x25mm
BCS
Adapter installed on
Adapter installed on
wrong side of T-Bar
wrong side of T-Bar
To prevent damage to the
Advertisement
