Advertisement
3
9691
9513
2584
3x12mm CS
Install the new roof skid plate onto the body along with
the original rear body reinforcements and body cage.
Insert the wire harness connectors through the hole in
the roof.
6
6590
Turn the body over (viewing the underside) and fasten the high-voltage power
amplifier to the body cage using the included 3x15mm cap screws (2). Position the
amplifier so that the 4 lighting connection ports point to the front of the body. Plug
the 4 LED harness connectors into the power amplifier, matching the colors on the
wires with the corresponding colors on the amplifier ports (white, yellow, red, blue).
4
Feed the wire harness connector
9510
from the body bumper light bar
through the larger cut hole in the
body, and then through the hole
in the bumper mount. Install
the bumper and bumper
mount on the body using
the included 3x10mm cap
screws (4).
5 A
Wipe Clean
Wipe Clean
9516
2584
3x12mm CS
Clean any dirt and grime from the body surface (5A). Use isopropyl rubbing alcohol
to remove any oily residue, wax, or grease. This will improve the bond between the
adhesive foam block and the body. Peel the adhesive backing from the included foam
block and attach it to the body as shown (5B, 5C).
2586
3x15mm CS
9692
5 B
High-Voltage Power Amplifier
Connection Ports
Front Bumper LED Light Bar (white)
Front Roof LED Light Bar (yellow)
Rear Roof LED Light Bar (tail lights) (red)
Rear Roof LED Light Bar (reverse lights) (blue)
Bottom View Installed
2587
3x10mm CS
5 C
Advertisement
