Basic Rail Rack-Mount Installation; Basic Rail Rack-Mount Removal; Fixed Bracket Rack-Mount Installation - Cisco MARS Install And Setup Manual

Chapter 4 Installing the Appliance

Basic Rail Rack-Mount Installation

Extend the inner rail until it locks.
Step 1
Depress the spring safety lock to release the inner rail.
Step 2
Remove the inner rail from the rail assembly.
Step 3
Attach the outer rail slides to the rack posts using two #10-32 x 1/2 screws at the front posts, and two
Step 4
#10-32 x 1/2 screws at the rear posts.
Note
Insert the inner rails over the server chassis sidewall studs.
Step 5
Slide the inner rails toward the front of the server chassis.
Step 6
Secure the inner rails with one #6-32 x 1/4 screw for each rail.
Step 7
Align the inner rails (attached to the server chassis) with the outer rail assemblies (attached to the rack).
Step 8
Step 9 Engage the matching rails and slide the server chassis into the rack until the two safety stops lock into
position.
Depress the two safety locks (one on each side).
Step 10
Step 11 Slide the server chassis all the way into the rack.
Step 12 Use the rack screws (#10-32 x 3/4) to secure the chassis and rack handles into the
End of Procedure

Basic Rail Rack-Mount Removal

Step 1 Disconnect all cables from the back of the system.
Tip
Pull the appliance from rack until brackets are fully extended.
Step 2
Step 3 Push in both clips on the brackets and slide the system forward until the inner rail separates from the
outer rail.
End of Procedure

Fixed Bracket Rack-Mount Installation

Fully extend a rail assembly; the finger tab for the extension lock is revealed.
Step 1
Press the finger tab and slide the inside rail from the middle rail until it completely
Step 2
OL-14672-01
The rail flanges mount to the inside of each post.
You can use the system LED to properly identify the system you are servicing.
Installing the MARS Appliance in a Rack
Install and Setup Guide for Cisco Security MARS
rack.
separates.
4-5