Table of Contents
Advertisement
Vertical Dist. to Dest.: The elevation distance between your current position and the final destination. You must
be navigating for this data to appear.
Vertical Dist. to Next: The elevation distance between your current position and the next waypoint in the route.
You must be navigating for this data to appear.
Vertical Speed: The rate of ascent or descent over time.
Vertical Speed to Dest.: The rate of ascent or descent to a predetermined altitude. You must be navigating for
this data to appear.
Waypoint at Dest.: The last point on the route to the destination. You must be navigating for this data to appear.
Waypoint at Next: The next point on the route. You must be navigating for this data to appear.
Optional Accessories
Optional accessories, such as mounts, maps, fitness accessories, and replacement parts, are available at
http://buy.garmin.com
or from your Garmin dealer.
tempe
The tempe is an ANT+ wireless temperature sensor. You can attach the sensor to a secure strap or loop where
it is exposed to ambient air, and therefore, provides a consistent source of accurate temperature data. You must
pair the tempe with your device to display temperature data from the tempe.
Tips for Pairing ANT+ Accessories with Your Garmin Device
• Verify that the ANT+ accessory is compatible with your Garmin device.
• Before you pair the ANT+ accessory with your Garmin device, move 10 m (33 ft.) away from other ANT+
accessories.
• Bring the Garmin device within range 3 m (10 ft.) of the ANT+ accessory.
• After you pair the first time, your Garmin device automatically recognizes the ANT+ accessory each time it
is activated. This process occurs automatically when you turn on the Garmin device and only takes a few
seconds when the accessories are activated and functioning correctly.
• When paired, your Garmin device receives data from only your accessory, and you can go near other
accessories.
Troubleshooting
Maximizing Battery Life
You can do several things to extend the life of the batteries.
• Turn off the screen
(Using the Power Button,
• Reduce the backlight brightness
• Reduce the backlight timeout
• Reduce the flashlight brightness or flash frequency
• Use battery save mode
• Use expedition mode
(Turning On Expedition Mode,
• Turn off wireless connectivity
• Turn off Bluetooth technology
• Turn off additional satellite systems
Restarting the Device
If the device stops responding, you may need to restart it. This does not erase any of your data or settings.
1 Remove the batteries.
2 Reinstall the batteries.
3 Hold
.
62
page 5).
(Adjusting the Backlight,
(Display Settings,
page 49).
(Turning On Battery Save Mode,
(Wi‑Fi Settings,
page 49).
(Bluetooth Settings,
(GPS and Other Satellite Systems,
page 5).
(Using the Flashlight,
page 38).
page 49).
page 50).
page 49).
page 48).
Appendix
Advertisement
Table of Contents
