Checking The Wiper Blades - Ford ECOSPORT 2016 Owner's Manual

Hide thumbs Also See for ECOSPORT 2016:
Table of Contents

Advertisement

E164689
1.
Remove the two screws from the
powertrain control module cover.
2
3
E164690
2. Remove the negative battery cable.
3. Remove the positive battery cable.
E164691
4. Remove the two nuts from the clamp.
5. Remove the battery.
EcoSport (CBY) Haiduong (Vietnam)/Rayong (Thailand), DN15-19A321-GC enPHI
Maintenance
6. Install in the reverse order.
Note: If you only disconnect the negative
battery cable terminal, make sure it is
isolated or placed away from the battery
terminal to avoid un-intended connection
or arcing.
Note: Make sure the battery cable terminals
are fully tightened.
Note: If you disconnect or replace the
battery, you must reset the clock and the
pre-set radio stations once the battery is
reconnected.
Battery Disposal
E107998
Seek advice from your local authority
regarding recycling.
CHECKING THE WIPER
BLADES
E142463
Run the tip of your fingers over the edge of
the blade to check for roughness.
Clean the wiper blades with washer fluid
or water applied with a soft sponge or
cloth.
135
Make sure that you dispose of
old batteries in an
environmentally friendly way.

Advertisement

Table of Contents
loading

Table of Contents