Led Diagnostics; Leds On The Garden Shears - Stihl HSA 26 Instruction Manual

English
To mount the wall charger:
2
1 b
c
a
► Mount the charger indoors in a dry room near an electrical
outlet.
► Sink the screws into a wall stud. Use appropriate screw-in
wall anchors or other similar mounting devices if an
appropriate wall stud is not available.
► Align the charger as shown above. Mount to a wall with the
following dimensions:
– a = minimum 18 in. (450 mm)
– b = minimum 3.9 in. (100 mm)
– c = 2.1 in. (54 mm)
– d = 0.2 in. (4.5 mm)
– e = 0.4 in. (9 mm)
– f = 0.1 in. (2.5 mm)

12 LED Diagnostics

12.1 LEDs on the Garden Shears

12.1.1 Garden Shears Status
The LEDs on the garden shears show the status of the
power tool.
If three LEDs glow red continuously: the garden shears
motor is too hot. Allow the motor to cool down.
22
If three LEDs flash red when you activate the trigger switch:
the garden shears has an electrical malfunction. Do not
operate the garden shears. Have it checked by an
3
authorized STIHL servicing dealer before use or storage.
For troubleshooting information, @ 23.
12.1.2 Battery Status
e
d
The same LEDs on the garden shears also indicate the
status of the battery.
f
These LEDs can glow or flash green or red.
f
If one LED glows red continuously: the battery is either too
hot or too cold. Allow the battery to warm up or cool down
gradually at an ambient temperature of about 50 °F to 68 °F
(10 °C to 20 °C).
If all 4 LEDs flash red: the battery has a malfunction and
must be replaced. Do not attempt to charge, use or store the
battery.
12.1.3 Charge Status
The LEDs on the garden shears also show the battery's
state of charge.
To determine the battery's state of charge:
1
► Insert the battery.
► Press the button (1).
The LEDs on the garden shears will glow or flash green for
about 5 seconds and indicate the state of charge (see
illustration).
12 LED Diagnostics
80-100%
60-80%
40-60%
20-40%
0-20%
0458-601-8221-A