Table of Contents
Advertisement
Contents
Service
Number
1
Indication for
the inner data
of IC6001
2
Indication for
the inner data
of IC6001
Contents of Indication on
minute
Starting / finishing edges
detecting data
(Real time)
00: Both starting /
finishing edges have not
been
01: Starting edge is
detecting now
02: Finishing edge is
detecting now
03: Both starting /
finishing edges are
detecting now
Mechanism position
(Real time)
0L: EJECT position
02: DOWN position
03: RREW position
04: LOAD position
05: REV position
06: PLAY position
07: POFF position
08: STOP_R position
09: STOP_F position
- : FF/REW position
- : Intermediate between
each positions
Contents of Indication on
second
Data of receiving key (Real
time)
Indicate the receiving
code when the key of VCR
or remote controller being
operated.
Ordering for the Motors
(Real time)
0*, 2*: CYL off,
CAP off
1*: CYL off,
CAP on (fwd)
3*: CYL off,
CAP on (rev)
8*, A*: CYL on,
CAP off
9*: CYL on,
CAP on (fwd)
B*: CYL on,
CAP on (rev)
*0: Motor off
*1: Loading
*2: Unloading
*3: Break (Load + Unload)
43
Remarks
There are next conditions
in this mode for enable
mechanism operations
without a cassette
The starting / finishing
edges are not detected.
The reel lock is
detected
The tape and the
positions are not detected.
, And so on.
Press the EJET key
over 3 seconds in this
mode, and then the
shifted into the special
modes, such as PG
Adjustment, Model
Setting, and so on.
The orders for the motors
are as follows.
Bit 7: CYL ON/OFF
Bit 6: ------------------
Bit 5: CAP FWD/REV
Bit 4: CAP ON/OFF
Bit 3: ------------------
Bit 2: ------------------
Bit 1: UNLOADING(
Bit 0: LOADING(H)
Advertisement
Table of Contents
