Fault Messages In The Display Unit - Panasonic 5054 Technical Manual

7

Fault Messages in the Display Unit

"General fault in system"
Displayed when any fault not corrected or serviced in the system and any non-acknowledged
fault in the system. To see the faults, refer to the FDCIE menu system.
Note: General fault is shown only when 5054 configured as external presentation unit, but not
displayed for alert annunciation unit.
"No contact with control unit"
The contact with the FDCIE is interrupted for > 45 sec. This fault is also indicated by LED
indicator.
Check cable, all connections, and the communication module 4552 in the FT128
•
FDCIE
• Is a correct / complete SSD download (via EBLWin) performed without errors?
Check the address and SW mode settings in the display unit.
•
"File system update failed. Waiting for command over USB"
Something went wrong during the download, or the wrong file was downloaded. Try to
download again, see section 9.4 "File System Download" page 25. Ensure that the file
system software version matches the firmware version.
"File system damaged. Waiting for command over USB"
Something went wrong during the download, or the wrong file was downloaded. Try to
download again, see section 9.4 "File System Download" page 25. Ensure that the file
system version matches the firmware version.
"File system version incompatible. Waiting for command over USB"
Something went wrong during the download, or the wrong file was downloaded. Try to
download again, see section 9.4 "File System Download" page 25. Ensure that the file
system version matches the firmware version.
"Failed to mount file system! Waiting for command over USB"
Something went wrong during the download, or the wrong file was downloaded. Try to
download again, see section 9.4 "File System Download" page 25. Ensure that the file
system version matches the firmware version.
"Failed to load layout from file system! Waiting for command over USB"
Something went wrong during the download, or the wrong file was downloaded. Try to
download again, see section 9.4 "File System Download" page 25. Ensure that the file
system version matches the firmware version.
18
Technical Manual
5054 Rev 0
For Firmware V2.0.x