2. Make sure you are logged on as System Administrator on the computer.
3. Go to Start menu / Configure EBL Service.
4. Browse for the EBL Graphics XML-file folder.
5. Enter the IP address of the PC.
6. Enter the port number.
7. Click Save and close.
8. Open the Windows Control Panel / Administrator Tool / Service.
9. Select EBL Service and click Start.
The IP address of the PC with EBL Service installed also need to be set in EBLWin.
10. Open the Display unit 5054 properties window in EBLWin as shown in Figure 5
below.
11. Enter the Server IP address and Server port.
12. If a static IP number (not DHCP) shall be used the following data have to be
specified:
IP address (for display unit)
•
Netmask
•
Gateway
•
20
Technical Manual
5054 Rev 0
For Firmware V2.0.x