Furuno FR-1500 MARK-3 Series Installation Manual page 38

Location of DIP switches, jumper wires on the GYRO CONVERTER
Board
Figure 4-3 GYRO CONVERTER Board
Setting the bearing on the radar display
Confirm that the gyrocompass is giving reliable bearings. Then, set bearing on
the radar display as follows:
1. Press the ]MENU] key.
2. Press the [0] key twice to display the OTHER menu.
3. Press the [1] key twice to select the HDG ADJ option.
4. Rotate the EBL control to adjust the radar's gyrocompass reading.
5. Press the [ENTER/SELECT] key to register the setting and the [MENU] key to
close the menu.
4-6