Table of Contents
Advertisement
SETUP MODE
ENTERING THE PASSWORD
The Setup Mode allows the user to set all
needed characteristics of the meter .
To enter the mode, press the SETUP key and
enter the password when the device is in idle
or control mode .
If the correct password is not entered, the user can only
view the setup parameters (except for passwords) without
modifying them (and the device remains in control mode) .
An exception is certain setup items, or flags, which can
activate special tasks, when set and confirmed .
To each setup parameter (or setup item) is assigned a three
characters (one letter followed by two digits) setup code
which is entered and displayed on the secondary LCD . The
first character identifies the group of setup items, while the
two digits identify the particular item within that group .
The setup codes can be selected after password is entered
and CFM key is pressed . When CFM is pressed, the current
setup item is saved on EEPROM and the following item is
displayed .
The possible transitions in setup mode are the following:
• Press SETUP to enter the setup mode . The primary LCD will
display "0000", while the secondary LCD shows "PAS" .
The first digit of the primary LCD will blink .
• Enter the first digit of the pass-
word by using the or key .
• Then move to the next digit with and
enter a digit as described above . Continue
for the last two digits .
23
Advertisement
Table of Contents
