For Rgb/Dvi - Maxent MX-50X1 User Manual

For RGB / DVI
Accessing Picture Adjustment Mode
Various picture adjustments can be set using the Picture
Adjustment OSD menu. To access the OSD menu:
1. Press the MENU +/- keys on the remote or the front
control panel.
2. The first menu displayed is the PICTURE menu.
Make sure that the "Picture" OSD menu is displayed.
3. Use the MENU +/- keys to move up and down to
choose the option you wish to adjust. An explanation
of each adjustment is listed below.
4. Use the ADJ +/- keys to change the setting.
Notes:
These controls are
available when input
selection is set to: RGB
or DVI inputs.
To restore picture
settings to the factory
defaults, simply press
the RECALL key from
the remote control.
Notes:
1. Each of the (4) color temperature settings may not be exactly equal to the temperature setting as
defined; however, it will be approximately close.
2 If you never enter "ADVANCED SETTING" menu (see page 30), the CUSTOM mode in COLOR
TEMPERATURE will not be available.
PICTURE ADJUSTMENT
CONTRAST
Adjust Contrast to increase the level of "white" in the video picture.
Increasing contrast will make white areas of the video picture brighter.
Contrast works in conjunction with BRIGHTNESS.
BRIGHTNESS
Adjust brightness to enhance the level of dark areas in the video picture
such as night scenes and shadow scenes. Increasing brightness will
make dark areas more visible.
COLOR TEMPERATURE
Select the color temperature for white balance. There are five settings to
choose from: (1) 6500D - sets the white balance to 6500D; (2) LOW - sets
to 5400K; (3) MID - sets to 9300K; (4) HIGH - sets to 13800K; (5) CUSTOM
- sets to user defined mode.
CLOCK PHASE
Use clock phase to fine-tune the display to perfectly synchronize the
video's signal source.
SCREEN WIDTH
Use to change various screen width modes. There are two selections
available: 16:9 and 4:3. Please see page 22 for more information.
V-SIZE
Use to change vertical size of the picture. Increase to enlarge the picture
size in the vertical direction. Decrease to reduce the picture size in the
vertical direction.
V-CENTER
Use to change vertical position of the picture. Increase to shift the picture
up. Decrease to shift the picture down.
H-WIDTH
Use to change horizontal size of the picture. Increase to enlarge the
picture size in the horizontal direction. Decrease to reduce the picture
size in the horizontal direction.
H-POSITION
Use to change horizontal position of the picture. Increase to shift the
picture to the right. Decrease to shift the picture to the left.
37