Connecting A Set-Top Box; Component Video Input; Rgb Input - Maxent MX-26X3 Owner's Manual

Connecting a Set-Top Box

Using Component Video Input
There are two sets of component video inputs provided. You can use either set of component inputs to connect
your STB. Some HDTV Set top boxes may not have a Component Video output. Instead, use RGB input
method.
Connect the green-colored (labeled as Y) jack
from the STB to the green-colored jack of the
monitor.
Connect the red-colored (labed as Pr or Cr) jack
from the STB to the red-colored Pr1/Cr1 jack of
the monitor.
Connect the blue-colored (labed as Pb or Cb)
jack from the STB to the blue-colored Pb1/Cb1
jack of the monitor.
Connect the red (R) and white (L) audio jacks
from the STB to the R and L audio-in jacks
located next to the Pr/Cr1 connector.
Using RGB Input
Connect the 15-pin D-Sub RGB connector from
the back of the HDTV set top box to the RGB-
IN Connector located on the back of the
monitor.
Connect the red (R) and white (L) audio-out
jacks from the HDTV set top box to the R and L
audio-in jacks located next to the RGB
connector.
Notes:
Some HDTV Set top boxes may not have a RGB output. Use Component Video input or DVI input
method if this is the case.
Upon connecting your HDTV set top box to the RGB input of the monitor,it may be necessary to
adjust various picture settings on the monitor to correctly match the output of the HDTV set top box.
This is caused by the different video timings set by various HDTV set top box manufacturers. (See
Page 40 for more information).
Display Connections
HDTE SET-TOP BOX
-
17