Preparing For Installation - Viessmann Vitogate 300 Nstallation And Service Instructions

Vitogate 300 Installation and Service

Preparing for Installation

Intended use
Install and operate Vitogate products as intended
in conjunction with the electronic control units and
controllers for the Viessmann heat and power generators
designed for this system, giving due consideration
to the associated installation, service and operating
instructions. In particular, observe the current and voltage
specifications for connections and hook-ups.
Use of the Vitogate products are exclusively for
monitoring, operating and optimizing systems with the
user and communication interfaces specified for this
purpose in the relevant printed documentation.
In the case of communication interfaces, ensure on site
that the system requirements specified in the product
documentation are met at all times for every transfer
medium employed. Only use the specified components
for the mains power supply (e.g. mains power adaptors).
Legend
A Power supply unit
B Vitogate 300
Product information
The Vitogate 300, type BN/MB gateway is designed to
integrate the Vitotronic control units using the integral
LON communication module (accessory*) to BACnet or
Modbus control systems. For supported appliances/
devices and further information, see www.vitogate.info.
The Vitogate 300, type BN/MB must be integrated into
the BACnet or Modbus control system by an authorized
contractor.
* Depending on the relevant control, this may be an
additional accessory item.
Functions
The Vitogate 300, type BN/MB enables system users
to utilize the following functions in conjunction with a
BACnet or Modbus control system:
H Adjustment of the heating system operating states
(standby/heating mode)
H Setting heating system parameters (temperature setpoint)
H Relaying fault and error messages
Vitogate 300, type BN/MB and its power supply unit are
suitable for mounting on a DIN rail (TS35 Top Hat Rail
35 mm x 15 mm or 35 mm x 7.5 mm).
Installation
5