Commissioning - Viessmann Vitogate 300 Nstallation And Service Instructions

Vitogate 300 Installation and Service

Commissioning

Devices required for commissioning:
H PC/laptop with the following equipment:
– Minimum monitor resolution 1024 x 768
– Integral or external Ethernet network module
– PDF Reader
H Supported web browsers:
– MS Internet Explorer V 7 or higher
– Mozilla Firefox V 2 or higher
– Mobile Safari V 3.1 or higher
– Google Chrome V 18.0 or higher
H Twisted pair network cable
Enabling the DHCP server
Dynamic Host Configuration Protocol (DHCP) makes
IP addresses available to clients on request.
If the computer has been set up as DHCP client
(standard setting), the DHCP server of the Vitogate 300
can be used to provide an IP address.
Hold down the reset button on the Vitogate 300 for at
least 5 sec, but no longer than 10 sec.
The DHCP server has been enabled once the LED LON
status flashes green/red alternately.
Note: The DHCP server does not need to be enabled
if a manual IP address is to be used.
Creating an Ethernet network
Connect the computer network module by means of
a twisted pair network cable with the RJ45 connection
of the Vitogate 300.
Creating a connection with the Vitogate 300 configuration
webserver
An IP address is automatically assigned to the computer
if the DHCP server has been enabled.
If a manual IP address is to be used, make the following
settings on the computer:
H IP address: 169.254.0.2 (or higher)
H Subnet mask: 255.255.0.0
H Standard gateway: Leave blank.
Calling up the Vitogate 300 configuration webserver
Open the Vitogate 300 configuration screens:
Start web browser:
H Enter IP address 169.254.0.1 into the address line.
H User name: vitogate
H Password: viessmann
You can change the password later.
The gateway default screen is called up.
Note: The configuration screens are described in the
integral Vitogate 300 online help.
Commissioning
15