Table of Contents
Advertisement
PROBLEM
Dishwasher will
not start
Lower spray
arm rotates
with difficulty
Cover of
detergent
dispenser
cannot be
closed
Remnants of
detergent stuck
inside dispenser
Water
remains inside
dishwasher
after wash
has ended
TROUBLESHOOTING
POSSIBLE CAUSE
No power.
The door is not
properly closed.
has not been pressed.
Water tap not turned on.
Blocked strainer in water
inlet hose.
Spray arm holes are
blocked by small items or
food particles.
Detergent compartment has
been overfilled.
Detergent dispenser is
clogged with remnants
of detergent.
Compartment was damp
when filled with detergent.
Utensils are blocking
the detergent dispenser
from opening.
Blocked drain connection.
Drain hose is crimped, bent,
or blocked.
Pump is jammed.
Filter(s) blocked.
WHAT TO DO
Ensure the dishwasher is plugged in and
the power supply is turned on at the wall.
Close the door.
Press .
Ensure water is connected and turned on.
Check the strainer and clean if necessary
– it is located where the water inlet hose
screws into the tap.
Clean the spray arm. Refer to
'Maintenance' for instructions.
Remove detergent until the cover can
be closed.
Wipe dispenser out with a damp
cloth. Dry the dispenser before
adding detergent.
Wipe dispenser out with a damp
cloth. Dry the dispenser before
adding detergent.
Ensure there are no large utensils
positioned in a way that will stop the
dispenser cover from opening when the
dishwasher door is closed.
Check that drain connection is free
from blockages.
Check the drain hose and straighten
if needed.
Clean the pump. See 'Fault codes'
for instructions.
Clean the filter(s). See 'Maintenance'
for instructions.
31
Advertisement
Table of Contents
