Lexus LS 500h Manual page 88

Hide thumbs Also See for LS 500h:
Table of Contents

Advertisement

88
2-1. Instrument cluster
Engine speed
On hybrid vehicles, engine speed is pre-
cisely controlled in order to help improve
fuel efficiency and reduce exhaust emis-
sions etc.
There are times when the engine speed that
is displayed may differ even when vehicle
operation and driving conditions are the
same.
Hybrid System Indicator is displayed
when
The Hybrid System Indicator is displayed in
the following situations:
The shift position is in D or M.
The driving mode is other than sport
mode.
Outside temperature display
In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low speeds
(less than 12 mph [20 km/h])
• When the outside temperature has
changed suddenly (at the entrance/exit of
a garage, tunnel, etc.)
When "--" or "E" is displayed, the system
may be malfunctioning. Take your vehicle
to your Lexus dealer.
Liquid crystal display
P.91
Customization
The gauges and meters can be customized
on
of the multi-information display.
(P.94)
LS500h_OM_(U)_1810
WARNING
The information display at low tem-
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low tem-
peratures, the information display
monitor may respond slowly, and display
changes may be delayed.
For example, there is a lag between the
driver's shifting and the new gear number
appearing on the display. This lag could
cause the driver to downshift again,
causing rapid and excessive engine brak-
ing and possibly an accident resulting in
death or injury.
NOTICE
To prevent damage to the engine and
its components
Do not let the indicator needle of the
tachometer enter the red zone, which
indicates the maximum engine speed.
The engine may be overheating if the
engine coolant temperature gauge is
in the red zone (H). In this case, imme-
diately stop the vehicle in a safe place,
and check the engine after it has
cooled completely. (P.450)
Odometer and trip meter dis-
play
Display items
 Odometer
Displays the total distance the vehicle has
been driven.
 Trip meter A/trip meter B
Displays the distance the vehicle has been
driven since the meter was last reset. Trip
meters A and B can be used to record and
display different distances independently.
 Distance until next engine oil

Advertisement

Table of Contents
loading

Table of Contents