Table of Contents
Advertisement
50
1-2. Child safety
Rear-facing Infant seat/con-
■
vertible seat
1
Adjust the rear seat
Vehicles with power rear seat: If there is a
gap between the child seat and the seat-
back, adjust the seatback angle until good
contact is achieved.
2
Place the child restraint system on
the rear seat facing the rear of the
vehicle.
3
Run the seat belt through the child
restraint system and insert the plate
into the buckle. Make sure that the
belt is not twisted.
4
Fully extend the shoulder belt and
allow it to retract to put it in lock
LS500h_OM_(U)_1810
mode. In lock mode, the belt cannot
be extended.
5
While pushing the child restraint
system down into the rear seat,
allow the shoulder belt to retract
until the child restraint system is
securely in place.
After the shoulder belt has retracted to a
point where there is no slack in the belt,
pull the belt to check that it cannot be
extended.
6
After installing the child restraint
system, rock it back and forth to
ensure that it is installed securely.
(P.53)
Forward-facing Convertible
■
seat
1
Adjust the seat
When using the front passenger
seat
If installing the child restraint system to
the front passenger seat is unavoid-
Advertisement
Table of Contents
