Table of Contents
Advertisement
20
en | Designing an MTS array
5
Designing an MTS array
5.1
Electro-acoustic design
5.2
Mechanical design
MTS-4153 models are equipped with 24 M10 external suspension points for connection of
eyebolts or 3
MTS-6154 models are equipped with 32 M10 external suspension points for connection of
eyebolts or 3
Use forged, load-rated shoulder eye bolts from a trusted supplier. The carbon steel eye bolts
in the Electro-Voice EBK-M10L-4HS High-Strength 45mm Eyebolt 4 Pack are ideal. Please read
and fully understand the EBK-M10L-4HS datasheet before use.
Never exceed manufacturer load ratings.
Never use unrated hardware.
The following suspension point load ratings are provided to guide qualified professionals while
designing support structures and suspension systems within a required safety factor.
5.2.1
M10 Suspension points: General
Remove the M10 fasteners from the loudspeaker carefully. Remove only one bolt at a time
from each bracket to prevent any chance that you dislodge the entire bracket when re-
inserting the bolts.
2021-09 | V01 | F.01U.386.524
1st
PREVIEW
rd
party suspension hardware.
rd
party suspension hardware.
Installation manual
MTS High Output Point Source
Use PREVIEW Loudspeaker Software to
design the array.
Note, PREVIEW helps optimize the acoustical
coverage, but does not validate the
mechanical mounting design.
You can also use EASE or EASE Focus to
model acoustics.
Electro-Voice
Advertisement
Table of Contents
