Removing A Media Card Reader - Dell Dimension 3100/E310 Service Manual

5. Attach the power and data cables to the floppy drive.
6. Connect the other end of the data cable to the connector labeled "FLOPPY" on the
1 FlexBay
2 power cable
3 data cable
7. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
8. Replace the
9. Replace the
NOTICE:
10. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
11. Enter system setup
12. Verify that your computer works correctly by running the
Media Card Reader

Removing a Media Card Reader

CAUTION:
NOTICE:
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
1. Follow the procedures in
2. Remove the
Great user manuals database on
drive panel.
computer cover.
To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.
and select the appropriate Diskette Drive option.
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
"Before You Begin."
drive panel.
UserManuals.info
system board
Dell Diagnostics.
and route the cable through the clip on the shroud.