TCS UbiquiSTAT US4050 Installation Manual
Commercial bacnet controller
Hide thumbs
Also See for UbiquiSTAT US4050:
- Product manual (50 pages) ,
- Product manual (32 pages) ,
- Configuration manual (22 pages)
Related Manuals for TCS UbiquiSTAT US4050
Summary of Contents for TCS UbiquiSTAT US4050
- Page 1 Installation Manual UbiquiSTAT Commercial BACnet Controller 2800 Laura Lane • Middleton, WI 53562 | 800.288.9383 | www.tcsbasys.com 202211...
-
Page 2: Table Of Contents
Contents Introduction ............................3 Opening the UbiquiSTAT ........................3 Mounting the UbiquiSTAT ........................3 Powering the UbiquiSTAT ........................3 UbiquiSTAT Wiring Connections ......................4 Active Terminations ................................ 4 Power ....................................5 RS-485 Port ..................................5 Packaged Unit Terminations ............................6 Time Clock Output ................................6 Analog Outputs ................................ -
Page 3: Introduction
BACnet Explorer to edit the device's BACnet programming objects directly. If you have any questions regarding your UbiquiSTAT room controller, do not hesitate to contact TCS Technical Support at 800-288-9383, ext. 2. Our Technical Support Department hours are Monday – Friday, 7:00 a.m. to 7:00 p.m. (CST). -
Page 4: Ubiquistat Wiring Connections
Installation UbiquiSTAT Wiring Connections The input/output terminals on the UbiquiSTAT utilize de-pluggable terminal blocks, with either two or three poles. Refer to the color-coded diagram below, which indicates which terminations are active on the various models. Packaged Unit Time Clock Analog Terminations Output... -
Page 5: Power
Connect the power source using 18AWG two-wire twisted, stranded copper wire. NOTE: Do not connect to 120VAC. When multiple TCS/Basys Controls devices are using a single transformer, be sure to maintain the polarity of the power wiring. All TCS devices are half-wave rectified and have common return paths. -
Page 6: Packaged Unit Terminations
Installation Packaged Unit Terminations Packaged unit signals may be up to 28VAC from the equipment terminations. W1 W2 AO1 AO2 GND – DI3 GND +P AI1 AI2 GND W1 W2 W1 W2 ‘20 ‘40 ‘50 ‘10 Time Clock Output The Time Clock Output is an unpowered, isolated pair of relay contacts. Connect an external device that operates with a schedule based on room occupancy, such as an outdoor air dampener or exhaust fan. -
Page 7: Digital Inputs
Installation Digital Inputs Digital inputs are used to receive status signals such as filter status, fan status, etc. Use unpowered dry contacts only with 18AWG two-wire twisted, stranded shielded or unshielded wire. DI1 DI2 DI3 GND W1 W2 AO1 AO2 GND –... -
Page 8: Assembling The Ubiquistat
Installation Assembling the UbiquiSTAT Before assembly, check that no wiring interferes with the cover, and no bare wires are exposed. Follow the instructions below. You can also refer to a video illustrating the assembly process by clicking here. STEP 1 Match the orientation of the internal connectors.