Section 2: Unpacking And Inspection; General; Required Tools; Unpacking - Generac Power Systems 10 kW Owner's Manual

Section 2: Unpacking and Inspection

General

NOTE: Carefully inspect contents for damage
after unpacking. Unpack and inspect unit
immediately upon delivery to identify any dam-
age which may have occurred in transit. Any
claims for shipping damage must be filed as
soon as possible with freight carrier. This is
especially important if unit will not be installed
for a period of time.
• This standby generator is ready for installa-
tion with a factory supplied and pre-
mounted base pad and has a weather pro-
tective enclosure intended for outdoor
installation only.
• If any loss or damage is noted at time of
delivery, have delivery person(s) note all
damage on the freight bill, or affix their sig-
nature under consignor's memo of loss or
damage.
• If a loss or damage is noted after delivery,
separate damaged materials and contact
freight carrier for claim procedures.
• "Concealed damage" is understood to
mean damage to contents of a package not
evident at time of delivery, but discovered
later.

Required Tools

• General SAE and Metric hand tools
– Wrenches
– Sockets
– Screwdrivers
• Standard electrician's hand tools
– Drill and bits for mounting and rout-
ing conduits
• 4 mm hex key (for access to customer con-
nections)
• 3/16 in hex key (test port on fuel regulator)
• Manometer (for fuel pressure checks)
• Meter capable of measuring AC/DC voltage
and frequency
• Torque wrenches
Installation Guidelines for 60 Hz Air-Cooled Generators

Unpacking

Proceed as follows to unpack the generator:
1.
Remove outer shipping carton.
2.
See 2-1. Remove wood frame.
Figure
Figure 2-1. Crated Generator
3.
See 2-2. Lid will be locked. A set of
Figure
keys is attached to the cardboard sheet on
top of unit. An additional set is attached to
the pallet bracket on the front intake end of
unit. Remove keys from cardboard and
pallet bracket.
Figure 2-2. Keys As Shipped
NOTE: The enclosed keys provided with this
unit are intended for service personnel only.
(Part number 0G66240KEY)
Unpacking and Inspection
000427
006729
7