Makita DOLMAR PS-32C Repair Manual page 26

11 CYLINDER / PISTON
Remove and reinstall the circlip 7 with needle-
nose pliers.
Install the piston with the arrow marking 8 on
the outlet side of the crankshaft (piston ring
lock on the inlet side).
The piston pin is on one side. See the
illustration for the installed position in the
piston.
Reparaturanleitung PS-4600 / PS-5000
Repair Manual PS-32
Assembling the cylinder and piston
Before assembly, wet the cylinder path,
8
piston and needle bearing with oil!
Use a new crankcase gasket and new seal
rings.
If the engine was removed to localize leaks,
insert the bushings (base to cylinder) into the
engine housing.
Insert the bottom half of the crankcase.
7
Position the crankshaft in the bottom half.
Further procedure as described in "Chap. 08
Carburetor" under Assembly.
When installing the ball bearing, please
note:
Use only pressure (assembly mandrel, Chap.
00 Pos. 14) to press the ball bearing onto the
bearing inside ring on the crankshaft. When
pressing it on, place a wedge between the
crank webs.
___
26