Makita DOLMAR PS-32C Repair Manual page 20

08 CARBURETOR
9
8
7
6
ON
Make sure that the intermediate flange goes
into its space on the cylinder side.
When lowering the cylinder make sure that the
pulse line 10 and the red fuel line 11 enter the
carburetor area.
Before completely lowering the cylinder make
sure that the short-circuit cable is led into the
openings 8.
Make sure that the return line (bottom
connection on primer) is behind the guide 12.
Install the combination switch 1 with the short-
circuit cable on top and then press the short-
circuit cable 7 under the holder 6.
Install the contact spring with short-circuit
cable.
Reparaturanleitung PS-4600 / PS-5000
Repair Manual PS-32
Tighten the screws 4 by hand evenly
10
alternating crosswise and then tighten to the
right torque (10 +/- 0.5 Nm), likewise
11
alternating crosswise.
Screw in screws 9.
12
Check the cylinder side annular spring on the
flange for correct seating.
Note: Before inserting the carburetor, make
sure that the carburetor mounting flange is
positioned horizontally.
Insert the carburetor and pulse line, and
connect the fuel lines.
Install the intake manifold 3 (3 +/-0.5 Nm).
Schematic diagram of the fuel lines
Red fuel line
Note: When installing the tank suction line,
make sure that the nose on the connection
nipple 14 is pushed into the position on the
connection as shown.
___
14
20