Troubleshooting - DeWalt DWV010X Instruction Manual

Problem
Motor does not run
Suction capacity decreases
Vacuum stops running
Dust comes out while vacuuming Check for proper installation of the filters.
Automatic filter cleaning is not
working
Power tool does not turn on the
dust extractor

TROUBLESHOOTING

solution
Check power cord, plugs and outlet.
Ensure the on/off switch is in the ON position ( ) and that the tool control switch is in
the OFF position ( ).
Remove blockages in the suction nozzle, suction tube, suction hose or filters.
Replace the paper or fleece bag.
Check for proper installation of the filters.
Clean or replace the filters.
Empty canister, refer to Empty Canister under Operation.
Thermal overload has been tripped:
1. Turn the vacuum off and disconnect vacuum cleaner from power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an appropriate outlet and turn on/off switch to the
ON position ( ) to test. If vacuum will not restart call 1–800–4-D
(1–800–433–9258).
Ensure filters are not damaged; replace if necessary.
Ensure filter seals are in place and are secure.
Listen for the solenoid clicking to ensure the filter cleaning mechanism is working.
Ensure tool is plugged into the tool outlet on the dust extractor.
Ensure the on/off switch is in the ON position ( ).
Ensure the tool control switch is in the ON position ( ).
English
WALT
e
9