Intended Use; Assembly And Adjustments; Operation - DeWalt DWV010X Instruction Manual

English
COMPONENTS (FIG. A)

WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Anti-Static Hose
The DWV010 is equipped with an anti-static grounding
system including an anti-static hose which will prevent
static shocks caused by vacuuming dry debris.

Intended Use

This vacuum is used for fine particulate pick-up, like
wallboard, concrete, wood or surface dust.
This product is NOT to be used for filtering of pathogens,
for example Covid-19. Follow all local, state, and federal
guidance on general cleaning practices.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty vacuums are for professional use.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
nOTE: This vacuum is intended for commercial use.

ASSEMBLY AND ADJUSTMENTS

(FIG. A, C–E)

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: When using electric appliances, always
follow basic safety precautions to reduce the risk of
fire, electric shock and personal injury.

WARNING: The filters
and tightened properly while vacuuming. Otherwise
hazardous dust could come through the unit, except
as described under Wet Pick Up Applications
under Operation. When vacuuming fine dust, you
may also use an additional paper bag or fleece bag to
make emptying the canister easier.
Fig. C
1. If optional paper or fleece bag
as shown in Figure D.
nOTE: Be careful not to tear the bag.Place bag securely
onto the backside of the inlet
for maximum dust collection performance.
4
15 must always be in place
15
13 is to be used, install
9 to provide a tight seal
Fig. D
9
Fig. E
2. Place the vacuum head
it by closing the canister latches
3. Insert end of hose
7
clockwise to lock in place.

OPERATION


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
To Operate the Vacuum (Fig. F)
1. Plug the power cord into an appropriate outlet.
2. If tool actuation of vacuum is desired, see Connecting
the Power Tools.
3. Turn on the main on/off power switch
nOTE: If the tool control switch
power cord is plugged into the outlet
will turn on briefly and then off again to indicate the
tool control switch 11
Fig. F
12
5
Connecting to Power Tools (Fig. A, G)
1. Plug the vacuum power cord into an appropriate outlet.
2. Plug the power tool into the outlet
the power tool is properly grounded.
13
9
7
3 onto the canister and secure
4 .
into hose inlet and rotate
9
5 .
11 is turned on, and no
12 , the vacuum
is in the ON position.
11
and make sure
12