Agri-Fab 45-0345-062 Owner's Manual page 7

(F) 5/16" x 3/4"
TRUSS HEAD
BOLT
(L) 5/16" HEX
LOCK NUT
(K) 1/4" HEX
LOCK NUT
FIGURE 8
15. Insert four 1/4" x 1" hex bolts (E) with 1/4" fl at washers
(J) down through the tray and the inside holes in the
latch stand plate. Secure the bolts with four 1/4" fl at
washers (J) and 1/4" hex lock nuts (K). Do not tighten
yet. See fi gure 9.
16. At this time tighten all bolts which were left loose.
(J) 1/4" FLAT
WASHER
(J) 1/4" FLAT
WASHER
FIGURE 9
17. Slide the handle into the channels in the latch stand
plate. Push the handle in all the way against the front of
the tray by depressing the detent buttons in the bottom
of the handle. See fi gure 10.
18. Assemble a 1/4" lock washer (I) and then a 1/4" fl at
washer (J) onto each of the two 1/4" x 1/2" screws (D).
Assemble the screws (D) into the small holes at each
end of the handle. See fi gure 10.
(E) 1/4" x 1"
HEX BOLT
(J) 1/4" FLAT
WASHER
(E) 1/4" x 1"
HEX BOLT
LATCH
STAND
PLATE
(K) 1/4" HEX
LOCK NUT
ENGLISH
BOTTOM OF CART
DETENT BUTTON
(J) 1/4" FLAT WASHER
(I) 1/4" LOCK WASHER
(D) 1/4" x 1/2" SCREW
FIGURE 10
CART WITH TONGUE ARRANGED FOR TOWING
(H) 3/8" x 1"
CLEVIS PIN
(G) 3/8" x 4"
CLEVIS PIN
FIGURE 11
19. Assemble the hitch pin (R) through the tongue and hitch
bracket and secure it with the 1/8" hairpin cotter (N).
See fi gure 12.
(R) HITCH PIN
FIGURE 12
7
HANDLE
LATCH LOCK
HITCH
BRACKET
(N) 1/8" HAIRPIN
COTTER
FRONT
TONGUE