Dell PowerEdge XR4000r Installation And Service Manual page 9

Table 5. AC PSU status indicator codes (continued)
Power indicator codes
Blinking green and powers off
Table 6. DC PSU status indicator codes
Power indicator codes
Green
Blinking amber
Not powered on
Blinking green
Condition
CAUTION:
unplug the PSU when updating firmware. If firmware
update is interrupted, the PSUs will not function.
When hot-plugging a PSU, it blinks green five times at a rate
of 4 Hz and powers off. This indicates a PSU mismatch due to
efficiency, feature set, health status, or supported voltage.
CAUTION:
must have the same type of label; for example,
Extended Power Performance (EPP) label. Mixing
PSUs from previous generations of PowerEdge
servers is not supported, even if the PSUs have the
same power rating. This results in a PSU mismatch
condition or failure to power on the system.
CAUTION:
the same type and have the same maximum output
power.
CAUTION:
the PSU with the blinking indicator. Swapping the
PSU to make a matched pair can result in an error
condition and an unexpected system shutdown. To
change from a high output configuration to a low
output configuration or vice versa, you must power
off the system.
CAUTION:
input voltages with the exception of Titanium PSUs,
which support only 240 V. When two identical PSUs
receive different input voltages, they can output
different wattages, and trigger a mismatch.
Condition
Indicates that a valid power source is connected to the PSU,
and the PSU is operational.
Indicates an issue with the PSU.
Indicates that the power is not connected to the PSU.
When hot-plugging a PSU, it blinks green five times at a rate
of 4 Hz and powers off. This indicates a PSU mismatch due to
efficiency, feature set, health status, or supported voltage.
CAUTION:
must have the same type of label; for example,
Extended Power Performance (EPP) label. Mixing
PSUs from previous generations of PowerEdge
servers is not supported, even if the PSUs have the
same power rating. This results in a PSU mismatch
condition, or failure to power on the system.
CAUTION:
the same type and have the same maximum output
power.
CAUTION:
the PSU with the blinking indicator. Swapping the
Dell PowerEdge XR4000r system configurations and features
Do not disconnect the power cord or
If two PSUs are installed, both the PSUs
If two PSUs are used, they must be of
When correcting a PSU mismatch, replace
AC PSUs support both 240 V and 120 V
If two PSUs are installed, both the PSUs
If two PSUs are used, they must be of
When correcting a PSU mismatch, replace
9