E7 Electric Connection; Figure 10 380-415V 3P+N; Figure 11 220-240V 3P - Electrolux EUC40G1 Instruction Manual

E7 Electric Connection

The electrical connection must follow the
regulations of the country where the machine is
installed.
Important Information!
The work on the electrical system
must only
qualified electrician.
⚫
Ensure that the power supply voltage (Table
1) indicated on the nameplate conforms to
the grid voltage.
⚫
Ensure that the power supply of the system
is arranged to bear actual load electric
current and follow the applicable regulations
of the country where the machine is installed
to professionally make construction work.
⚫
The earth wire of the terminal must be longer
than the phase cable (by a maximum 20
mm).
⚫
The earth wire of the power supply cable is
connected to the effective grounding clamp.
The equipment is also included in the
equipotential system and connected through
the bolt " B " (see E6.2 "Installation Drawing")
with marking "
equipotential
cross-section area of 10mm
be performed
" symbol.
cables must have
2
.
Power supply 380-415V 3P+N
(Standard)
by a
Connect the power supply as shown in Figure 10:
Use the supplied power supply cables ( I ) (refer to
technical data sheet). Connect the 3-phase
cable"L1,L2,L3,N "
circuit-breaker (G) which should be supplied by
the customer. Connect the PE to the customer's
ground terminal.
Power supply 220-240V 3P
The
a
Connect the power supply as shown in Figure 11:
Use the supplied power supply cables (I) (refer to
technical data sheet). Connect the 3-phase cable
16

Figure 10 380-415V 3P+N

to the residual

Figure 11 220-240V 3P

leakage