Agri-Fab 45-0345 Owner's Manual page 7

15. Insert two 1/4" x 1-3/4" hex bolts (D) through the handle
tube as shown in fi gure 8. Holding the bolts in place in
the handle, insert the bolts through the holes in the poly
tray, allowing the legs of the handle to slip beneath the
latch stand bracket. Secure the two bolts with two 1/4"
fl at washers (J) and 1/4" nylock nuts (K). Do not tighten
yet. See fi gure 8.
(K) 1/4"
NYLOCK NUT
FIGURE 8
16. Align the holes in the handle with the holes in the bottom
of the poly tray, the latch stand plate and the latch stand
bracket. Fasten together using four 1/4" x 1-3/4" hex
bolts (D), 1/4" fl at washers (J) and 1/4" nylock nuts (K)
as shown in fi gure 9. Tighten.
17. At this time tighten all bolts which were left loose.
(J) 1/4" FLAT
WASHER
(K) 1/4"
NYLOCK NUT
FIGURE 9
ENGLISH
(J) 1/4" FLAT
WASHER
(D) 1/4" x 1-3/4"
HEX BOLT
LATCH STAND
BRACKET
(D) 1/4" x 1-3/4"
HEX BOLT
CART WITH TONGUE ARRANGED FOR TOWING
(H) 3/8" x 1"
CLEVIS PIN
(G) 3/8" x 4"
CLEVIS PIN
FIGURE 10
18. Assemble the hitch pin (R) through the tongue and hitch
bracket and secure it with the 1/8" hairpin cotter (N).
See fi gure 11.
(R) HITCH PIN
FIGURE 11
7
LATCH LOCK
FRONT
TONGUE
HITCH
BRACKET
(N) 1/8" HAIRPIN
COTTER