Carrier X4 7300 Operation & Service Manual page 57

1. With the system powered up (START/RUN-OFF switch in the START/RUN position) or in PC Mode press
the MENU key until DATA RECORDER is displayed.
2. Press the DATA RECORDER soft key to display the sub menus.
3. The Data Recorder screen will display with a 15 second timeout. Press the ▲ or ▼ key to scroll through the
available sub menus. With the desired sub-menu highlighted, press the "=" Key to enter the menu.
MARK TRIP START
Trip Start places the present time and date as a stamp in the data recorder memory to allow easy
review of the data from the last trip, and to allow downloading data from a specific trip. A trip begins at a
Trip Start and ends at the next Trip Start. To enter a Trip Start: with MARK TRIP START highlighted,
press the "=" Key. If trip start is acknowledged by the data recorder, "TRIP START ENTERED" will be
displayed for 5 seconds and then the display will revert back to the normal display. In the unlikely situa-
tion that the data recorder is not functioning properly "CANNOT ENTER TRIP START" will flash and
then the display will revert back to the Data Recorder menu.
PRINT TO SCREEN
PRINT TO SCREEN displays a graphical representation of the recorded data. To display the data: with PRINT TO
SCREEN highlighted, press the "=" Key. NOTE: If configured to do so, the system will prompt for entry of the data
protect PIN code (refer to "PROTECT DATA WITH PIN",
Once the graphical display is presented, press the ▲ or ▼ keys to move through the recorded data, day by day.
The data is presented with the left horizontal axis as 00:00 (midnight) with 24 dividing lines representing the hours
of the day. Press the "=" key to toggle the event codes on or off. When viewing events with the event codes ON, the
following acronyms will be displayed:
62-11637
START/STOP
START/STOP START/STOP
CONTINUOUS
Viewing Menu Soft Key
DEFROST Viewing Menu Soft Key
Press Menu Key to Scroll
Press Menu Key to Scroll
MENU
1 INTELLISET
LANGUAGE
2
DATA RECORDER
MARK TRIP START
PRINT TO SCREEN
PRINT TO PRINTER
SCREEN SETUP
PRINTER SETUP
BACK
Collecting Data, Please Wait
Up Key = Next Day
Down Key = Previous Day
Equal Key = Event Toggle
EXIT
c = Door Close o = Door Open
d = Defrost start p = Power up
e = Defrost end r = Real time clock change
f = Power down t = Trip Start
ALARM
DIESEL DIESEL COOL COOL
Selections
Selections
PRETRIP HOUR UNIT
DATA EXIT
METERS DATA
RECORDER
NOTE: Choices vary based on
software revision and model
type.
EXIT
Table 5–1)
75
SETPOINT
60
45
30
15
Time & Date
3–12
RAT
SP
SAT
EXIT