Table of Contents
Advertisement
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
2-6-2 Headers
(1)
COM2 Serial Port Headers (9-pin) : COM2
This board has two serial port COM1 (Connector)/COM2(Headers), it come with cable
providing serial port COM1/COM2. The On-board serial port can be disabled through
BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS SETUP" section
for more detail information.
(2) Parallel Port Headers (25-pin Block): Parallel
The On-board Parallel Port can be disabled through the BIOS SETUP. Please refer to
Chapter 3 "INTEGRATED PERIPHERALS SETUP" section for more detail
information.
(2)
Line-Out, MIC Header (9-pin): AUDIO
This header connect to Front Panel Line-out, MIC connector with cable.
IDE1
IDE2
Pin 1
Pin 1
COM2
Note: Orient the read marking on the
Pin 1
AUDIO
10
9
AUD - R ET - L
AUD - RET - R
AUD - VC C
AUD - MIC - BIAS
AUD - G ND
2
Pin 1
Line-Out, MIC Headers
12
COM1/2 ribbon cable to pin 1
AUD - FPO UT - L
HP - O N
AUD - FPO UT - R
AUD - MIC
Advertisement
Table of Contents
