Table of Contents
Advertisement
Available languages
Available languages
Floppy Disk Drive Connector: FDD1
The mainboard provides a standard floppy disk drive
connector that supports 360K, 720K, 1.2M, 1.44M and
2.88M floppy disk types.
IDE Connectors: IDE1 & IDE2
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100/133
controller that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/100/133
function. You can connect up to four hard disk drives, CD-ROM, 120MB Floppy and
other devices.
The first hard drive should always be connected to IDE1. IDE1 can connect a Master
and a Slave drive. You must configure second hard drive to Slave mode by setting the
jumper accordingly. IDE2 can also connect a Master and a Slave drive.
MSI Reminds You...
If you install two hard disks on cable, you must configure the second drive to Slave mode by
setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper
setting instructions.
Fan Power Connectors: CPU_FAN1/SYS_FAN1/PWR_FAN1
The CPU_FAN1 (processor fan), SYS_FAN1 (system fan), and
PWR_FAN1 (power fan) support system cooling fan with +12V.
They support three-pin head connector. When connecting the
wire to the connectors, always note that the red wire is the positive and should be connected to
the +12V, the black wire is Ground and should be connected to GND. If the mainboard has a
System Hardware Monitor chipset on-board, you must use a specially designed fan with speed
sensor to take advantage of the CPU fan control.
MSI Reminds You...
Always consult the vendors for proper CPU cooling fan.
Serial ATA Connectors: SATA1 & SATA2
The mainboard provides dual high-speed Serial ATA interface ports. The
ports support 1st generation Serial ATA data rates of 150MB/s and are fully
8
Hide quick links:
Advertisement
Table of Contents
