Serial Ata Connectors: Sata1, Sata2; Bios Password Clear: Jpwd1 - MSI MS-7293 Series Getting Started

M S-7293 M ainboard

Serial ATA Connectors: SATA1, SATA2

SATA1, SATA2 are high-speed Serial ATA interface ports. Each supports 1
tion serial ATA data rates of 150MB/s and is fully compliant with Serial ATA 1.0
specifications. Each Serial ATA connector can connect to 1 hard disk device.
7
SATA1
SATA2
7
Serial ATA cable
Important
Please do not fold the Serial ATA cable into 90-degree angle. Otherwise,
data loss may occur during transmission.

BIOS Password Clear: JPWD1

The BIOS password protects the BIOS from undesired changes. If you
need to clear the BIOS password, use the following steps:
1. Turn off the system, then remove the jumper from JPWD1.
2. Power on the system, and BIOS would show "Password Cleared
By Jumper" during POST.
3. Press DEL key to enter BIOS Setup menu, and you'll find the BIOS
passwords are cleared.
4. Turn off the system, and put the jumper back on JPWD1.
2-12
1
PIN
1
3
5
7
1
Connect to SATA1, 2
SATA1, SATA2 Pin Definition
SIGNAL PIN
GND 2
RXP 4
TXN 6
GND
Take out the dust cover
and connect to the hard
disk devices
st
genera-
SIGNAL
RXN
GND
TXP
2
1
JPWD1